LED board setup
Bingo Marquee works with LED signs that take an HDMI (or DVI/DisplayPort) signal through a sending card or LED controller, such as NovaStar, Colorlight or similar.
How it works
Your PC sends the LED controller a normal video signal, usually 1920 × 1080. Your LED board is usually smaller than that, for example 724 × 208 pixels. Bingo Marquee draws the board at its exact pixel size in one corner of the signal (the top-left by default) and leaves the rest black. The LED controller then takes that area and shows it on the board, pixel for pixel.
The most important setting: the LED controller must not scale the picture. If it stretches the whole 1920 × 1080 signal onto the board, everything looks squished, blurry or cut off.
Step 1: Connect and extend
- Connect the PC's video output to the LED controller's input.
- In Windows, open Settings > System > Display. Set the LED output to Extend these displays (not Duplicate).
- Set that display's resolution to what the controller expects. 1920 × 1080 is the most common.
Step 2: Set up the screen in Bingo Marquee
- On the Screens tab, click Add a screen and choose LED board.
- HDMI output (the LED sending card): pick the output connected to the controller. Click Identify monitors if you're not sure which one it is.
- LED board size (pixels): enter the board's exact width and height in pixels. Your LED installer or the controller software can tell you this.
- Position in signal: where the board's picture starts inside the video signal. Leave it at X 0, Y 0 unless your controller is set to start somewhere else.
The preview shows the full signal with your board's area highlighted, and the app repeats the exact numbers to use in your controller.
Step 3: Set the LED controller to 1:1
In your LED controller's software, make the area it shows match what Bingo Marquee uses: the same start point (X and Y) and the same width and height, with no scaling.
- Basic sending cards (for example NovaStar's MCTRL series) already map pixels 1:1. You usually only set the start point and size so they match.
- Controllers with a built-in scaler, often called video processors (for example NovaStar's VX series), stretch the input to fit the board unless you change it. Turn scaling off, or set the layer or window to the board's exact size and position.
Menu names differ between controllers and software versions. If you can't find the setting, your LED installer can set it in a few minutes. Ask them to "map the top-left 724 × 208 of the HDMI input to the screen 1:1, no scaling", using your board's size.
Step 4: Check it
- On the Design tab, click Test call, or click GO LIVE.
- The board should fill the LED sign exactly: no stretching, no black bars, nothing cut off.
If it doesn't look right
- Squished, stretched or blurry: the controller is scaling. Turn scaling off or set it to 1:1.
- Cut off, or only part of the board shows: the board size or position in Bingo Marquee doesn't match the controller. Check both numbers.
- Shows your Windows desktop or the app itself: the display is set to Duplicate. Change it to Extend.
- Black: check you picked the right output, and that you clicked GO LIVE.
Still stuck? Send us a support file (Help > Save a support file) and a photo of the board.